Unable to distribute correction information when using a fixed station mode

Issue

Unable to distribute correction information when using a fixed station mode

Answer

If correction information cannot be delivered, please check the following possibilities.

Fixed station license has not been purchased.	If you have not purchased a license, you cannot use the device. If the device is rented, please inform the rental source of the serial number and confirm it.
Project Selection Issues Base station installation point selection issues	Error in coordinate system settings  Please check if the coordinate settings in the project site you are using are correct. Error in reference installation  If the reference point was imported from a CSV, please check for errors. In case of manual input, please check the value if the input is correct. If you used network RTK for input, please check if the coordinate settings in the project site are the same as those in the project site. (SIM card setting is required)
The sky is not clear enough at the installation site (poor GNSS reception)	Please change the location where Edge2 is installed and check the GNSS reception status with a tablet.
Wrong location of known points and Edge2	Please check if there is no mistake between the Edge2 installation location and the selected coordinate points, or if the registered localization is incomplete.
【Digital radio】 External radio, communication failure Error　0xa0300003	Try resetting the digital radio on the fixed station side. Check if there are any loose cables connecting to the digital radio.
【N-Trip distribution】 Duplicate/incorrectly entered ID and PASS when using the correction information service	There are cases where the ID/PASS managed by the purchaser or rental source is duplicated and cannot be distributed. Please check if the ID/PASS you or manager possess is not being used at another site. Please make sure that the ID and PASS are correct.
USB is inserted in Edge2	Fixed station distribution is not possible with USB plugged in, so please disconnect USB.
Tablet startup problem	If the project does not appear on the tablet, there may be a connection problem for some reason, please try rebooting the tablet. Please connect the tablet after the Edge2 is turned on and the green light comes on.